Hello! Welcome to Guizhou RITHI Electronic Science and Technology Co., Ltd.!
Think beyond Limits ·Strive for the extreme
Think beyond Limits ·Strive for the extreme
Specializing in the design, manufacturing, and sales of mid-to-high-end connectors, electronic components, and cable harnesses
Connecting the Future and Setting Sail Unlimited
Guizhou RITHI Electronic Science and Technology Co., Ltd.
Specializing in the design, manufacturing, and sales of mid-to-high-end connectors, electronic components, and cable harnesses
Guizhou RITHI Electronic Science and Technology Co., Ltd.
Suitable for interconnection of various electrical circuit systems with high-density, miniaturized, lightweight, and high reliability requirements
News Center
How to prevent overheating in the aviation plug and socket program
Category:
Release time:
2025-03-20 17:46
Aviation plug is electrically conductive, electronic equipment connection, the internal current flow, so after a period of time after the use of its surface will have heat transfer, so the heat is a normal phenomenon, but to prevent overheating, overheating will damage the aviation plug products.
Aviation plug is electrically conductive, electronic equipment connection, the internal current flow, so after a period of time after the use of its surface will have heat transfer, so the heat is a normal phenomenon, but to prevent overheating, overheating will damage the aviation plug products.
1. When the fault is found, dismantle the power cord aviation plug and unscrew the conductive column inside the electric water heater socket, and polish it with zero emery cloth or abrasive paste until it is bright. Electric water heater socket in the power cord and aviation plug contact tongue connection of the wire, connecting screws, tongue, and conductive column of the oxide layer, in order to reduce the contact resistance.
2. Apply a little conductive paste on the power cord connector and socket terminals of the electric water heater.
3. Aviation plugs should be replaced immediately if the upper tongue and wiring screws are badly burned.
4. If the socket and conductive column on the electric water heater are burned out seriously, it should be removed immediately and replaced with the same specification socket and conductive column. When installing the electric water heater socket, the power gate switch should be installed.
关键词:
relevant content